How to Replace Bathroom Vanity Sink Stopper - Do you have problem replace bathroom vanity sink stopper? Discover how to repair a faulty sink pop-up vanity sink stopper quickly. Find materials, illustrations and helpful tips for fast repair.
Disassemble and Clean the Pop-Up Stopper Assembly
Move all from under the sink, so you have an area to work. Check to find that the horizontal pivot rod is connected to the clevis. Change the retaining nut that holds the horizontal pivot rod in the spot. Take off the horizontal pivot rod from the drainpipe. Next, Mark the place where the clevis is connected to the vanity sink stopper rod with a permanent marker. Then loosen the clevis screw. Wash the clevis and horizontal pivot rod in mild cleaning solution or vinegar.
Lift the vanity sink stopper out of the drain. Inspect the rubber seal on the bottom of the vanity sink stopper head. If the seal is cracked or brittle, the vanity sink stopper should be replaced. If it is still in excellent condition, you can reuse it.
Dip the vanity sink stopper in vinegar or mild cleaner. Clean it thoroughly with a brush or an old toothbrush. Wash the vanity sink stopper and clean the clevis and horizontal pivot rod.
Reassemble and Adjust the Pop-Up Stopper Assembly
Insert the vanity sink stopper into the drain. Slide the clevis over the stopper rod and insert the horizontal pivot rod into the drainpipe. Tighten the retaining nut just sufficient to hold the horizontal pivot rod in place. Tighten the clevis screw where you marked it before. Test the vanity sink stopper rod to ensure all the moving parts are reattached. The clevis, horizontal pivot rod, and vanity sink stopper should all move when the vanity sink stopper rod is pulled.
Tighten the retaining nut just sufficient, so the vanity sink stopper rod doesn't slide down. If the retaining nut is too tight, the horizontal pivot rod won't move. Loosen the clevis screw, and pull the vanity sink stopper rod up. Slide the clevis up the vanity sink stopper rod as far as you can. Tighten the clevis screw.
The pop-up vanity sink stopper should hold water now. If not, continue to set the retaining nut and the clevis until you get a great seal.